The Quarter Bullnose Form has a gentle edge rounded edge finish excellent for your kitchen benchtops when you want to create a more traditional feel.
These Z Countertop Forms are designed to be attached to the cement board, which is screwed onto the top of the cabinets. The Z Countertop Forms are simply snapped off when the concrete is cured, leaving behind the decorative edge benchtop surface.
Creates a 57mm height edge to the cast-in-place concrete benchtop.
- Easy to use
- Cut to a custom length
- Cast-in-place concrete forms
- Clean cuts allow edges to align tightly
- No wooden framing required
- No heavy lifting
HALF PACKAGE
Includes four (4)- 2.4m pieces (9.6 linear meters) and three (3) - 2.4m back wall pieces (7.2m linear meters).
FULL PACKAGE
Includes eight (8)- 2.4m pieces (19.2 linear meters) and six (6) - 2.4m back wall pieces (14.4m linear meters).
CALCULATIONS
Approx. requirements per 1 sq.meter
STANDARD FORMS
3:1 RATIO MIX
1x 20kg bags of high strength mortar or White Portland cement
3x 20kg bags of fine washed sand
3x boxes of Z Liqui-Crete
The quantity is rounded up to a complete bag
Also, consider Z Clips and Alkali-resistant fibreglass mesh.
Quarter Bullnose Form
To use - place 2x 7.5mm cement boards on top of the cabinets carcass. The cement boards should be cut flush to the edge of the cabinets and held in place using silicone caulking between each layer of cement board. The forms will then be screwed into the cement board with 12mm x 10g Panhead screws. After the concrete is poured, the forms are snapped off along the designated 'breakpoint' to reveal a beautiful clean edge.