Full Bullnose Form

This form creates classic edge profile, choose a Full Bullnose edge when you want to create a more traditional feel on your benchtop.

 

These Z Countertop Forms are designed to be attached to the cement board, which is screwed onto the top of the cabinets. The Z Countertop forms are simply snapped off when the concrete is cured, leaving behind the decorative edge benchtop surface.

 

Creates a 57mm height edge to the cast-in-place concrete benchtop.

 

  • Easy to use 
  • Cut to a custom length
  • Cast-in-place concrete forms
  • Clean cuts allow edges to align tightly
  • No wooden framing required
  • No heavy lifting

 

HALF PACKAGE

Includes four (4)- 2.4m pieces (9.6 linear meters) and three (3) - 2.4m back wall pieces (7.2m linear meters).

 

FULL PACKAGE

Includes eight (8)- 2.4m pieces (19.2 linear meters) and six (6) - 2.4m back wall pieces (14.4m linear meters).

 

CALCULATIONS

Approx. requirements per 1 sq.meter

STANDARD FORMS

3:1 RATIO MIX
1x 20kg bags of high strength mortar or White Portland cement

3x 20kg bags of fine washed sand

3x boxes of Z Liqui-Crete

The quantity is rounded up to a complete bag


Also, consider Z Clips and Alkali-resistant fibreglass mesh.

Full Bullnose Form

$245.00Price
  • To use - place 2x 7.5mm cement boards on top of the cabinets carcass. The cement boards should be cut flush to the edge of the cabinets and held in place using silicone caulking between each layer of cement board. The forms will then be screwed into the cement board with 12mm x 10g Panhead screws. After the concrete is poured, the forms are snapped off along the designated 'breakpoint' to reveal a beautiful clean edge.