Oxide Colour Pack

The Colour-Pack is a pre-measured bag of integral pigment meant for use with White Portland Cement. Combine one Color-Pack with one bag of White Benchtop Mix to get the colour shown in the colour charts attached. 


Colour-Pack can be used with any 20kg concrete bagged mix but colours will vary depending on the concrete mix used. 

Colours (Colour Chart Below)

Bright White - ~340 grams. Titanium Oxide (4% colour load in White Portland Cement) - Will whiten concrete


Always test by making a sample piece first to confirm results.

Do not exceed one Color-Pack per bag of White Portland Cement.


As a general rule - coloured oxide is added at a ratio of 1% - 4% by weight of cement in the mix. Too higher a concentration of oxides will make the resultant mix weak. Please make a sample first and get it approved before you proceed with the entire job.

NOTE: Colors may vary. This colour chart is meant to be used as an approximation only. 

Oxide Colour Pack

  • Data Sheets and instructional application tips can be found under our Resources section. HERE

  • Warning: Colors may vary. This color chart is meant to be used as an approximation only. All of these color swatches were created using the Concrete Countertop solutions White Countertop Mix. Using this concrete mix will yield similar colors to what you see below but a test should always be done first since monitor colors settings will cause variation in what you see on your screen.